How to heat-prepare Quick Fix 6.2 synthetic urine

Quick Fix Kit How to heat-prepare Quick Fix 6.2 synthetic urine

In this article we are going to talk about how to heat-prepare Quick Fix 6.2 synthetic urine. We will also cover common questions and concerns we get asked daily. Quick Fix urine currently has two preparation methods to utilize when heating up the urine. The most common methods are outlined below in a step by step process. If you have other questions regarding how to use Quick Fix please read our FAQ page found in the link below. https://www.quickfixsynthetic.com/faq/

Option 1. The fastest and most effective way to get your Quick Fix 6.2 kit warm in a snap.

  1. Remove the kit from the box
  2. Unscrew the cap and place the unit in the microwave for 10 seconds
  3. Remove the bottle and re apply the cap provided in the kit
  4. Shake the bottle
  5. Open the provided heating pad included shake well.
  6. Using the rubber band provided attach it to the bottle opposite the temp strip
  7. Secure the liquid somewhere on your body to remain un detected
  8. The urine will now remain in the acceptable range of 92°-99°
  9. If you do not get a greenlight reading on the temp strip it is too hot let it cool.Microwave to heat Quick Fix Urine

Option 2. The slower method of heating Quick Fix 6.2 if you have no microwave access.

  1. Remove the kit from the box
  2. Open the provide heating pad and shake vigorously
  3. Using the rubber band provided attach it to the bottle opposite the temp strip
  4. Secure the liquid somewhere on your body to remain un detected
  5. This will now take approximately 30-40 minutes to reach the desired temp
  6. Shake the bottle until you get a green light reading that shows 92°-99° degree range
  7. If you do not get a greenlight reading on the temp strip it is likely not warm enough.

Common problems that might occur when heating up synthetic urineQuick Fix directions

A common mistake people make when using fake pee is the preparation method. The directions indicate you only need to microwave the urine for 10 seconds. If you put the bottle in the microwave for say 15-20 seconds and don’t worry you did not ruin it, you simply over heated it. You will know if the sample is over heated by the following 2 signs.

  1. The bottle is hot but there is no temperature reading on the green strip attached to the bottle.
  2. You have shaken the sample and there is still no reading.

 

This common mistake will in no way ruin the samples validity so no need to worry there. Simply let the bottle cool on the counter say 5 minutes or longer then repeat the entire process from start to finish utilizing the 10 second method no longer.

The second most common problem when getting synthetic urine ready for use is not removing the cap. Like anything being warmed things expand, so be sure to remove the cap to prevent over heating and potential explosion of the plastic bottle.

What to do prior to using your Quick Fix synthetic urine kit.Are You Prepared

Below are some essential steps along with photo tips on what to look for prior to use. This can be found on the little green insert located inside the kit top left code to be exact. You can call your Quick Fix batch number in or check it on the website.

  1. Quick Fix batch numbers- Always check your batch number prior to use. This can be found on the little green insert located inside the kit top left code to be exact. You can call your Quick Fix batch number in or check it on the website.

2. Buy from a direct source- Here is a link to the most popular product Quick Fix Plus https://www.quickfixsynthetic.com/product/quick-fix-6-2-plus/

3. Where to hide the Quick Fix- Most common is you’re under wear, but feel free to get creative. Here are a few options.

4.  Follow the instructions- For the non-readers here is a info graphic visual on Quick Fix 6.2 Quick Fix

 

 

 

 

Comments are closed.